Florii 1 Wall Lamp PRO: Installation & Room Ideas

Quick answer

Install the Florii 1 Wall Lamp PRO in dark bronze by mounting the backplate securely, connecting to a standard junction box, and attaching the white polycarbonate shade for a warm, indirect glow.

Installation steps

1. Turn off power and mark the mounting height: Switch off the circuit breaker for the room. Hold the backplate against the wall at your desired height (typically 60-66 inches from the floor for general lighting, or 48-54 inches for bedside reading). Use a level to mark screw holes. Double-check that the power is off before drilling to avoid electric shock.
2. Drill pilot holes and insert wall anchors: Use a drill bit matching your anchors (usually 3/16-inch for drywall). Drill at your marks, insert plastic anchors, and tap them flush. For solid walls, skip anchors and use masonry screws. If you hit a stud, switch to wood screws; never rely on drywall anchors alone for this lamp's weight.
3. Wire the backplate to the junction box: Connect the lamp's black wire to the house black (hot), white to white (neutral), and green or bare copper to ground. Use wire nuts and tuck wires neatly into the box. Screw the backplate onto the wall anchors. Verify wire connections are tight and that no bare copper is exposed outside the wire nut.
4. Attach the white polycarbonate shade: Align the shade's mounting ring with the backplate's clips or screws (consult your manual for the exact mechanism). Gently press or twist until it clicks or locks into place. Do not overtighten. Polycarbonate can crack if forced; if it does not seat easily, check alignment rather than applying more pressure.
5. Test the lamp and adjust the angle: Restore power and turn on the switch. Observe the light pattern: the shade should glow evenly without dark spots. If the lamp includes an adjustable arm, tilt it to direct light where needed. If the light flickers, the dimmer may be incompatible; try a standard switch or a dimmer rated for LED loads.

Product facts

• Florii 1 Wall Lampe, PRO, dark bronze / white: The Florii 1 Wall Lamp features a dark bronze backplate and a translucent white polycarbonate shade that creates a warm interplay of light and shadow. The dark bronze finish hides fingerprints well in high-traffic areas, while the white shade diffuses light evenly without harsh glare.