Asteea Ceiling PRO: Install & Style Satin Brass

Quick answer

Install the Asteea Ceiling PRO by mounting the canopy to a standard junction box, connecting the wires, and securing the ripple clear glass shades. Style it in living rooms or entryways where indirect, glare-free light is desired.

Installation steps

1. Mount the canopy: Secure the canopy to the ceiling junction box using the provided screws. Ensure the canopy is level and the gasket is seated properly to prevent drafts. Common mistake: overtighting screws can warp the canopy. Tighten until snug, then stop.
2. Connect wiring: Connect the fixture wires to the house wires: black to black (live), white to white (neutral), and green or bare copper to ground. Use wire nuts and wrap with electrical tape. Tuck connections neatly into the junction box. Always double-check polarity. A reversed neutral can cause the fixture to hum or flicker.
3. Attach the glass shades: Slide each ripple clear acrylic shade onto the arm and secure with the retaining ring. Do not overtighten—acrylic can crack if compressed too hard. Inspect each shade for chips or cracks before installation. Damaged shades may not seat evenly.
4. Restore power and test: Turn the circuit breaker back on and flip the wall switch. The fixture should light evenly with no flicker. If it does not light, turn off power and recheck wiring connections. If the light flickers, it is usually a loose neutral wire. Tighten the wire nut connection.

Product spotlight

• Asteea Ceiling, PRO, satin brass / ripple clear: Two light sources are mounted on a single arm, giving the lamp a light and elegant expression. This means you get more light output from a compact flush mount, ideal for rooms where you want brightness without a bulky fixture.